Tabla de contenido
Idiomas disponibles
Idiomas disponibles
10
DUAL FLUSH MODELS ONLY
ADJUSTMENTS
a.
Adjust water level. Water level should be adjusted
to level indicated on tank by adjusting as follows:
1. Major water level adjustment - see Page 4
2. Minor water level adjustment - see Page 4
b.
Flush Valve Setting Adjustments
FLUSH VALVE
SETTINGS
Heavy Flush Float
Heavy Flush Door
Light Flush Float
Re ll Float Cup
Re ll Door
c. Refill Control set at 2
NOTE: All other settings will result in either more
or less water and are not recommended.
• To remove Flush Valve, apply slight
downward pressure and twist it until the
flush valve disengages from the bayonet.
• To reinstall Flush Valve, reverse the
above procedure.
FOR PUSH BUTTON DUAL FLUSH MODELS:
Install the Button Rods (see
lower button until 2-7/8" (75mm) rod length is achieved.
FLUSH BUTTONS ON TANK
The Light Flush Button (with 3 dots) should line up over the blue actuator on the flush tower in the tank.
The Heavy Flush Button (with 9 dots) should line up over the white actuator on the flush tower in the tank.
Light Flush Button (with 3 dots) for liquid waste.
TIPS:
If the bowl still does not flush properly after following the steps
outlined in the troubleshooting guide, remove the tank lid and
push one of the flush buttons on top of the flush valve in the
tank. If the flush appears to be normal, you will need to adjust
the length of the threaded rods for the push buttons mounted
on the tank lid with the settings as follows:
1. Turn the lid upside down.
2. Loosen the black plastic lock nut.
3. Adjust the white threaded rod one turn counterclockwise.
4. Re-tighten the black plastic lock nut.
5. Put lid back on tank and test the flush. If it is still not
flushing properly, repeat Tips Steps 1 through 4 (above)
until the problem is resolved.
6. If one counterclockwise turn is too much and causes the
flush valve to stay open, adjust 1/2 turn clockwise and
tighten lock nut.
*
:
WITHOUT
WITH
LINER
LINER
8
5-1/2
5
5
12
9
8
7
2
2
*
See table (Step 10b) for
Flush Valve Setting Adjustments
A
below) by threading into
FOR SINGLE FLUSH MODELS GO TO STEP 12
PUSH BUTTON
4
2
0
9
8½
6
5
LIGHT FLUSH
FLOAT
ADJUSTMENT
BLACK PLASTIC
LOCK NUT
WHITE
THREADED ROD
A
- 3 -
WATER LINE
1 1
FULL
MIN
7
5
3
1
MAX
1 1
FULL
MIN
7
5
3
1
MAX
SILICON
SEAL
1
1 1
HALF
FULL
MIN
MIN
7
7
5
3
5
1
3
1
MAX
MAX
HEAVY FLUSH
HEAVY FLUSH
FLOAT
DOOR
ADJUSTMENT
*
ADJUSTMENT
*
Heavy Flush Button (with 9 dots) for solid waste.
BLACK PLASTIC
LOCK NUT
WHITE
Continued on
THREADED ROD
next page
INSTALL & ADJUST ROD
LENGTH TO 2-7/8" (75mm)
7301416 - 10 0 Rev. N 5 / 18
REFILL
FLOAT
*
CUP
2
*
REFILL DOOR
1
*
Tabla de contenido
