7- Programming With Operation For Rolling Shutters - Vimar ELVOX ECG3 Manual Para El Conexionado Y El Uso

Terminal number Description
1 Earth wire
2-3 Power supply line 230Vac 50Hz
4
Electric motor common
5 Power supply for closing electric motor
6 Power supply for opening electric motor
6.2 Connecting opening, closing and safety buttons
Terminal number Description
7
GND common (COM)
8 Opening and stopping command (IN1)
9
Closing and stopping command (IN2)
10 Input for safety device, normally closed contact (IN3)
11 GND common (COM)
The presence sensing device must have a normally closed N.C. contact, it will be wired between terminal IN3 and the COM terminal.
If the opening / closing safety device is engaged, no opening or closing movement will be possible.
If you've started a closing movement and if during the travel the closing safety device is engaged, as a result there will be:
In manned mode, an immediate stop of the closing movement.
•
In automatic mode, a brief reversal of movement (opening).
•
If you've started an opening movement and if during the travel the opening safety device is engaged, as a result there will be:
• In manned mode, an immediate stop of the opening movement.
• In automatic mode, a brief reversal of movement (closing).
7 Programming with operation for rolling shutters
7.1 Rolling shutters with automatic operation
The "automatic" mode lets you make the movement by momentarily pushing a button, either on the push-button panel or on the remote controller.
The movement can be stopped by pressing the same button again or reversed by pressing the other button.
The total travel time is determined by the trimmer TR1; after this time the control unit cuts off the power supply to the electric motor. The time is set with TR1
from a minimum of 4 seconds to a maximum of 255 seconds, as shown in the image:
22
All manuals and user guides at all-guides.com
Open
Closed
Safety
N.C.
Open
Closed
Safety
N.C.
EN