Idiomas disponibles
Idiomas disponibles
GB
Our products are designed to attain the highest quality, functionality and design standards. We hope you enjoy your new X3 ceramic-
titanium hair clipper from PALSON.
Usage instructions
-
Read these instructions carefully before using this appliance.
-
After reading them, make sure to put them in a place that is easy to access.
-
This appliance is not designed to be used by people (including children) with physical, sensory or mental disabilities or who have no
experience or knowledge, except when supervised or have been given instructions on the use of the appliance by the person looking
after them. Children must be supervised to ensure that they do not play with the appliance.
-
If the cable is damaged, it must be replaced by the manufacturer or its authorised technical service or by a qualified engineer to
prevent dangerous situations.
Warning:
Make sure to apply oil on the blade before and after using the hair clippers.
-
On the contrary, the blade may pull on your hair and damage the blade.
-
Please, use the supplied oil or other suitable oils.
-
The oil supplied with the hair clippers is only for use with this blade, and is not suitable for any other purpose.
-
Do not charge or use the appliance at temperatures under 0 ºC or over 40 ºC.
-
Do not charge the battery in direct sunlight or close to a radiant heat source.
-
Do not charge, use or put the hair clippers in cold and humid places, or in places at high temperatures.
-
Do not leave the hair clippers to charge unattended.
-
WARNING: Do not submerge the hair clippers in liquids.
How to charge it
1.
Turn the switch on the main appliance to "O" (off).
2.
Plug the adaptor into the mains socket.
3.
The charging light will turn red when it has been plugged in.
4.
The battery will be fully charged when it has been charging for 8 hours.
5.
Avoid recharging the battery for more than 12 hours, as this will shorten its useful life.
6.
Once the battery has been charged, remove the adaptor from the mains socket.
7.
Turn the switch to "I" (on) to use the appliance.
8.
Turn the switch to "O" (off) when you have finished using the appliance.
How to use the appliance connected to the cable.
1.
Turn the switch to "O" (off).
2.
Plug the adaptor into the mains socket and the other end directly into the appliance.
3.
The red light will come on when it has been plugged into the mains socket.
4.
Turn the switch to "I" (on) to use the hair clippers.
5.
Turn the switch to "O" (off) when you have finished using the appliance, and then remove the cable from the appliance and from the
mains socket.
4, 6, 9 and 12 mm accessory combs.
1.
To assemble and accessory, turn the switch to "O" and slide it parallel to the blade.
2.
To remove the hair clippers' accessory comb, push it in the direction indicated by the arrows (Fig. 3).
Cutting without accessories
Cut the hair placing the hair clippers head directly on the hair (Fig. 4). You can adjust the cutting length turning the knob (5) clockwise to
increase the length and anticlockwise to reduce it. You can select 5 different lengths from 0.8 to 2 mm.
Assembling and disassembling the blade
1.
Hold the hair clippers firmly and push the blade with your thumb in the direction indicated by the arrow (Fig. 2).
Whilst doing so, hold the blade with the other hand. Make sure that the switch is turned to "O" before attempting to remove the
blade.
2.
To reassemble the blade, insert the support catch into the blade holder on the hair clippers and push it until it clicks (Fig. 5).
8
