Maintenance And Inspection - EGAmaster 66556 Manual De Instrucciones

Destornillador dinamométrico

Ocultar thumbs

Contenido

página de 33

/ 33
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

It is recommended to set the direction on the controller first, before setting screw removal,

which includes CW and CCW. Please refer to the following table for 9-level torque and speed

setting. The torque to remove screw should be larger than that to fasten screw. For detailed

controller setting, please refer to 66549 controller operating manual.

Controller:

Program setting

Direction

CCW

5) Attaching / detaching bit and bit type

Pull down the holder clamp by finger tip, and it will be unlocked. Thus, the bit can be freely

attached and detached (single finger notion type) select such a bit whose shank is equal to the

size shown below.

6) LED Lighting auxiliary lighting

Please refer to the 66549 operation manual for setting adjustment.

7) Front Cover Thread: fixed auxiliary arm use.

8) Press-plate Start

Pressed down sensor screwdriver starts functioning when the switch trigger has been

pressed down; on the contrary, it stops when the screw has been tightened up or the trigger has

been released.

1. The sensor screwdriver must be operated in top condition, one day working hour must be

not more than eight hours.

2. Please note don't let the motor get over heated, every minute use 9 screws to operate.

3. The frequency use of this electric sensor screwdriver is over than eight hours a day, still it

needs periodically testing and treatment.

4. Inspect tool cords periodically and if damaged, have them repaired by an authorized service

facility. Inspect extension cords periodically and replace if damaged.

5. Do not remove any labels. Replace any damaged label.

6. To adjust the torque on these sensor screwdriver. Proceed as follows:

Stop the sensor driver first and adjust it with the 66549 controller.

Screwdriver light

signal (action)

Forward

Backward

Forward