Installation And Initial Operation - EAS ELECTRIC EMR1092DS2 Manual De Instrucciones

SECTION 3

INSTALLATION AND INITIAL OPERATION

Selection of Installation Places
Operating environment of the product is very important to
ensure that your product operates without any problem.
When you are selecting the operating environment,
 Do not place your product outdoors so that it shall be
exposed to weather conditions. (on a street, lane, etc.)
 Do not place materials such as cardboards, boxes, etc. in
front of the lower blinds to ensure proper cooling of your
product.
 Place it at least one (1) meter away from heat sources
(stove, radiator, electrical heater, etc.) (Figure 1)
 Do not expose to direct sunlight. Operation rate of your
appliance will be increased if sunlight hits the glass of your
cooler. And this causes an increase in the temperature of
the products inside the appliance and the power con-
sumption shall be increased. (Figure 2)
 Do not place it against A/C exhausts, under the fans and
directly in the door and window openings. (Figure 3)
 Air entrance and exit shall always be free and easy for
proper operation of the compressor section of your applian-
ce.
 Make sure that there is a clearance of 150 mm (15 cm)
between the wall and the rear side of your cooler when you
are bringing the product close to the wall.
Picture 1 Picture 2
11
Picture 3