Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Use only genuine EAS Electric spare parts. Non-genuine
spare parts may cause risks for you and may damage your
product.
Place your product where you desire. Consider the placing
rules specified in the manual during placement.
Level your product laterally and vertically with a spirit level.
Perform the levelling procedure with the adjustable legs
on the front lower part of your cooler.
OPERATION OF THE COOLER
Rules for Electrical Connection
Your appliance shall operate when you plug it to an outlet.
ATTENTION!
Do not plug your appliance to a multi-socket or do not use
an extension cord.
Your product is not equipped with an on/off switch.
Do not allow the cables of your product connected to the
mains to contact hot surfaces. Outlet that shall be used shall
always be grounded. It the outlet that shall be used shall
also be protected with a proper fuse with a rating of 10-16 A
minimum. Always get support from our authorized service
or a qualified electrician for the fuse that shall be installed
on the electrical installation where the outlet is connected.
(Figure 6)
The voltage and frequency of mains power should be the
same as the values specified on the label on the inner
surface of your appliance. If mains power is far below or
above the specified value, have the desired voltage by using
a voltage regulator. You can get help from a qualified
electrician.
Do not put the cable of your product on passage routes.
These may cause injury to you and damage to your cooler.
18
V.1
Capítulos
Tabla de contenido
