Gardena AssistCut Instrucciones De Empleo página 17

(2)
the ON / OFF switch
off and then on again.
Battery supported Secateurs:
The AssistCut provides power-assisted cutting. It is
operated like a pair of manual secateurs and cuts
small branch diameters without power assistance.
For larger branch diameters, the integrated motor
switches on for power assistance. Noise develop-
ment while power-assisted cutting is active, is nor-
mal. Power-assist feature is only active as long as
gripping force is exerted on the handles. If no force
is exerted onto the handles, the AssistCut stops.
2-stage opening width of the handles
[ Fig. D ]:
(3)
The interlock has 3 settings:
P0
AssistCut is locked
P1
First opening width for smaller hands
P2 Second opening width for larger hands
3. MAINTENANCE
DANGER! Risk of physical injury!
Cut injury when the product starts
accidentally.
v Close the handles, lock the blade, turn
off the product and use gloves before
you maintain the product.
To clean the AssistCut:
DANGER! Risk of physical injury!
Risk of injury and risk of damage to
the product.
4. STORAGE
To put into storage:
The product must be stored away from
children.
1. Slide the ON / OFF switch
OFF position.
2. Charge the battery.
3. Clean the AssistCut (see 3. MAINTENANCE).
4. Store the AssistCut in a dry, enclosed and
frost-free place.
12222-20.960.01.indb 17 12222-20.960.01.indb 17
must first be switched
(2)
forward to the
Tips to use the AssistCut:
– Never cut too close to the stem so the wound
can heal properly.
– Always make the cut about 8 mm from the bud.
– The cut should slope away from the bud so the
rain can run off.
– If you remove an entire stem, cut back to the
point where it branched.
– Never push the blade of the AssistCut into the
ground to cut root suckers.
– Cut branches one by one.
– Remove overcrowds or crossing stems.
– Remove thin or weak growth.
– Always remove dead, damaged and diseased
branches.
v Do not clean the product with water
or with a water jet (in particular high­
pressure water jet).
v Do not clean with chemicals including
petrol or solvents. Some can destroy
critical plastic parts.
1. Clean the AssistCut with a damp cloth.
2. Spray the blade with the GARDENA Cleaning
Spray, Art. 2366.
Avoid contact of the oil with the plastic parts.
Disposal:
(in accordance with RL2012/19/EC /
S.I. 2013 No. 3113)
The product must not be disposed of to
normal household waste. It must be dis-
posed of in line with local environmental
regulations.
IMPORTANT!
v Dispose of the product through or via your
municipal recycling collection centre.
17
21.03.22 08:06 21.03.22 08:06