After Finishing Work - Stihl SR 340 Manual De Instrucciones

!
Warning!
To reduce the risk of fire and burn injury,
keep the area around the muffler clean.
Remove excess lubricant and all debris
such as pine needles, branches or
leaves. Let the engine cool down sitting
on concrete, metal, bare ground or solid
wood (e.g. the trunk of a felled tree)
away from any combustible substances.
!
Warning!
Never modify your muffler. The muffler
could be damaged and cause an
increase in heat radiation or sparks,
thereby increasing the risk of fire and
burn injury. You may also permanently
damage the engine. Have your muffler
serviced and repaired by your STIHL
servicing dealer only.
SR 340, SR 420

After Finishing Work

Always wash thoroughly with soap and
water after spraying or handling
chemicals. Shower immediately, and
wash all protective clothing separately
from other items. Follow any additional
recommendations of the chemical
manufacturer.
Always clean dust and dirt off the power
tool.
!
Warning!
Empty, rinse and clean container and
assembly after each use. This helps to
prevent the solution from crystallizing,
which could later cause clogging and
chemical damage to the unit. In addition;
residual chemicals may have
undesirable effects during subsequent
spraying with a different type of chemical
(e.g., residual herbicide may damage or
kill plants being sprayed with a
pesticide).
Disposal of contaminated rinse should
be in accordance with applicable
ordinances. Observe the precautionary
instructions of the chemical
manufacturer.
Do not store the mistblower with spray
solution in the container.
English / USA
MAINTENANCE, REPAIR AND
STORING
Maintenance, replacement, or repair of
the emission control devices and
systems may be performed by any
nonroad engine repair establishment or
individual. However, if you make a
warranty claim for a component which
has not been serviced or maintained
properly or if nonapproved replacement
parts were used, STIHL may deny
coverage.
!
Warning!
Use only identical STIHL replacement
parts for maintenance and repair. Use of
non-STIHL parts may cause serious or
fatal injury.
Strictly follow the maintenance and
repair instructions in the maintenance
chart near the end of the instruction
manual.
!
Warning!
Always stop the engine and make sure
that the fan is stopped before doing any
maintenance or repair work or cleaning
the power tool.
13