Tabla de contenido
Idiomas disponibles
Idiomas disponibles
All manuals and user guides at all-guides.com
pressure by depressing trigger, and disconnect power source. NEVER
assume system pressure is zero!
MATERIAL.
The cup provided with this gun is designed for siphon feed only, it is ideal for
applying light and medium bodied paints (stain, lacquer) to large size jobs such
as complete auto refinishing. For spraying on larger painting applications the
gun can be used with a remote pressure feed paint tank.
IMPORTANT: This gun is designed to be use with most finishing materials. It is
not designed to be used with corrosive or highly abrasive materials. Using these
materials can lead to poor performance and/or failure of this product.
FINGER IN FRONT OF FLUID NOZZLE.
NOT EXCEED PRESSURE LIMIT OF GUN OR ANY OTHER COMPO-
NENT IN SYSTEM!
connections for a weak or worn condition that could render system
unsafe. All replacement components such as hose or fittings must have
a working pressure equal to or greater than system pressure.
Before use
G
Install a moisture
separator/regulator when there
is a possibility moisture will
damage the surface to be
painted. Install the moisture
separator/regulator as close to
the tool as possible.
NOTE: Liquid water occurs
naturally in air lines as a result
of compression. The moisture
exiting near the compressor is
warm and still in a vapor state which allows it to pass through the moisture
separator. The vapor must travel a minimum of 5 to 10 feet to cool down to
a liquid to be removed by the moisture separator. See Illustration.
G
Prior to shipment, this gun was treated with an anticorrosive agent. Before
using this gun make sure that it is carefully flushed with thinner.
D25867
GENERAL INFORMATION
Before disassembly or removal of any part of gun or
attached components, shut off compressor, release
TO AVOID CREATING AN EXPLOSIVE ATMOSPHERE,
WORK ONLY IN WELL-VENTILATED AREAS.
USE OF A NIOSH APPROVED FACE MASK IS
RECOMMENDED TO PREVENT INHALATION OF TOXIC
OPERATION
DO NOT ATTEMPT TO UNCLOG (BACK FLUSH) SPRAY
GUN BY SQUEEZING TRIGGER WHILE HOLDING
Pressure may vary according to viscosity of material
used. Maximum working pressure of gun is 100 psi. DO
Prior to daily operation, make certain that all
connections and fittings are secure. Check hose and all
4- ENG
Tabla de contenido
