LiftMaster 8160W Manual Del Usuario página 35

Operation
Features
Your garage door opener is equipped with features to provide you with greater control over your
garage door operation.
ALERT2CLOSE
The Alert2Close feature provides a visual and an audible alert that an unattended door is closing.
TIMER-TO-CLOSE (TTC)
The TTC feature automatically closes the door after a specified time period that can be adjusted using
a TTC enabled door control (Models 881LMW or 880LMW). Prior to and during the door closing the
garage door opener lights will flash and the garage door opener will beep.
MYQ
®
myQ technology uses a 900MHz signal to provide two-way communication between the garage
®
door opener and myQ enabled accessories. Your garage door opener is compatible with up to 16
®
myQ accessories.
SECURITY+ 2.0 REMOTE CONTROLS AND DOOR CONTROLS
Your garage door opener has already been programmed at the factory to operate with your remote
control, which changes with each use, randomly accessing over 100 billion new codes. Compatible
®
with myQ and Security+ 2.0 accessories, see page 45
NOTE: Older LiftMaster remote controls, door controls, and third party products are not compatible.
Security+ 2.0
Accessories
Remote Controls Up to 12
Door Controls Up to 2 Smart Control Panels or 4 of any other Security+ 2.0 door
controls
Keyless Entries Up to 1
®
THE PROTECTOR SYSTEM (SAFETY REVERSING SENSORS)
When properly connected and aligned, the safety reversing sensors will detect an obstruction in the
path of the infrared beam. If an obstruction breaks the infrared beam while the door is closing, the
door will stop and reverse to full open position. If the door is fully open, and the safety reversing
sensors are not installed, or are misaligned, the door will not close from a remote control. However,
you can close the door if you hold the button on the door control or keyless entry until the door is
fully closed. The safety reversing sensors do not effect the opening cycle.
MEMORY CAPACITY
LIGHTS
The garage door opener light bulbs will turn on when the opener is initially plugged in; power is
restored after interruption, or when the garage door opener is activated. The lights will turn off
automatically after 4-1/2 minutes. Use an incandescent A19 light bulb (100 watt maximum).
USING YOUR GARAGE DOOR OPENER
The garage door opener can be activated through a wall-mounted door control, remote control,
wireless keyless entry or myQ® App.
When the door is closed and the garage door opener is activated the door will open. If the door
makes contact with an obstruction while opening, the door will stop, opener beeps and lights flash 5
times. When the door is in any position other than closed and the garage door opener is activated,
the door will close. If the garage door makes contact with an obstruction while closing, the door will
reverse, opener beeps and lights flash 5 times. However, you can close the door if you hold the
button on the door control or keyless entry until the door is fully closed.
The safety reversing sensors do not affect the opening cycle. The safety reversing sensor must be
connected and aligned correctly before the garage door opener will move in the down direction.
BATTERY BACKUP*
The battery backup system allows access in and out of your garage, even when the power is out.
When the garage door opener is operating on battery power, the garage door opener will run slower,
the light will not function, the Battery Status LED will glow solid orange, and a beep will sound
approximately every 2 seconds.
*if applicable
35