Technical Data Robend 4000 E - Rothenberger ROBEND 4000 E Instrucciones De Uso

If battery fluid leaks out and comes into contact with
your skin, rinse immediately with plenty of water. If bat-
tery fluid leaks out and comes into contact with your
eyes, wash them with clean water and seek medical
attention immediately!
Transporting li-ion battery packs: The contained lithium-ion batteries are subject to the Dan-
gerous Goods Legislation requirements. The user can transport the batteries by road without fur-
ther requirements. When being transported by third parties (e.g.: air transport or forwarding
agency), special requirements on packaging and labelling must be observed. For preparation of
the item being shipped, consulting an expert for hazardous material is required. Only send the
battery pack if the housing is intact and no fluid is leaking. Remove the battery pack from the
machine for sending. Prevent the contacts from short-circuiting (e.g. by protecting them with ad-
hesive tape).
Dispatch batteries only when the housing is undamaged. Tape or mask off open contacts and
pack up the battery in such a manner that it cannot move around in the packaging. Please also
observe possibly more detailed national regulations.
2

Technical Data ROBEND 4000 E

Battery voltage ............................................ 18V
Battery capacity (recommendation) ............. ≥ 4.0 Ah
Dimensions (L x W x H, without battery) ..... 578 x 143 x 214 mm
Weight (without battery) .............................. 12,8 kg
Bending capacity ........................................ Copper 12-35 mm/ 1/2 - 1.3/8"
Bending angle ............................................. 0º - 180º
Noise pressure level (L
Sound power level (L
The noise level during operation can exceed 85 dB (A). Wear hearing protection!
Measured values determined in accordance with EN 62841-1.
Vibration total value .............................................................
The Vibration Total Value quoted in these instructions and the quoted noise emission values
were measured according to standardized measurement procedures and can be used to com-
pare one electric power tool with another. They can also be used to make an initial estimate of
the loading.
The quoted vibration and noise emissions can vary during actual use of the electric
power tool dependent on the way in which the electric power tool is used, in particular
what type of workpiece is being processed.
Establish additional safety measures to protect the operator which are based upon an
estimate of the vibration loading during the actual usage conditions (in doing so taking
account of parts of the operating cycle, for example times in which the electric power
tool is switched and those in which it is switched on but not running under load).
stainless steel/ carbon steel 12-28 mm/ 1/2-1.1/8"
) ........................... 87 dB (A) ¦ K
pA
) ............................. 100 dB (A) ¦ K
WA
≤ 5,9 m/s
ENGLISH
3 dB (A)
pA
3 dB (A)
WA
2 ¦ K= 1,5m/s 2
17