Kreg Jig K5 Manual Del Usuario página 11

All manuals and user guides at all-guides.com
Tips
10
Mitered Corners
For boards at least 3" (76mm) wide, pocket holes
drilled with the "A" and "C" guides both fit entirely on
the face of the board. In this situation, simply position
the mitered workpiece on the jig, clamp it in place,
and drill.
For boards at least 2 ⁄ " (60mm) wide, pocket holes
3
8
drilled with the "B" and "C" guides both fit entirely on
the face of the board. In this situation, simply position
the mitered workpiece on the jig, clamp it in place,
and drill.
Mitered Corners
To position a pocket screw close to the miter "toe" on a wide 30°
workpiece or to position a second pocket screw on a narrow
workpiece and still have the hole entirely on the face of the
part, drill the pocket hole closest to the miter heel with the drill
guide in the drill guide socket. Remove the guide from the
socket. For ¾" (19mm)-thick stock, attach a spacer block (U)
to the drill guide. Position the drill guide with the spacer-block
end 1½" (38mm) from the miter toe, and then angle the drill
1 ⁄ "
1
2
guide away from the toe at a 30-degree angle. Clamp the
(38mm)
drill guide in place and drill the pocket hole.
You also can drill one pocket hole on each side of a miter
joint rather than drilling both holes on the same side.
Joining ½" (13mm)-thick stock
When using the optional Micro Pocket Drill Guide and
drill bit with ½" (13mm)-thick stock, join the parts with
Kreg SPS-F075 screws. The small-diameter head
of these ¾" (19mm) panhead screws seats below
the workpiece surface to allow plugging with a Micro
pocket-hole plug.