Maintenance; Waste Management - S&P CR-TEMP Manual Del Usuario

14. Differential temperature open windows function (range: 2.0-6.0°C; by de-
fault: 4.0°C)
15. Time between measurements (range: 1-100; by default: 5)
Value multiplied by 50ms (Example: 1 = 50ms)
16. Consecutive measurement limits (range: ±1-±16; by default: ±1)
17. Temperature offset (range: -5.0-5.0°C; by default: 0.0°C)
18. Relay 2 operation (range: 0 a 4; by default 2)
0: No function
1: Air heater NO (Normally opened)
2: Air heater NC (Normally closed)
3: Alarm NO (Normally opened)
4: Alarm NC (Normally closed)
19. Communications address (without use)

6. MAINTENANCE

Before manipulating the fan, make sure it is disconnected from the mains supply
even if it has previously been switched off. Prevent the possibility of anyone else
connecting it while it is being manipulated.
Fan unit must be regularly inspected. These inspections should be carried out
bearing in mind the machine's working conditions, in order to avoid dirt or dust
accumulating that could be dangerous and perceptibly shorten the life expec-
tancy.
All maintenance and repair work should be carried out in strict compliance with
each country's current safety regulations.

7. WASTE MANAGEMENT

EEC legislation and our consideration of future generations mean
that we should always recycle materials where possible; please do
not forget to deposit all packaging in the appropriate recycling bins.
If your device is also labeled with this symbol, please take it to the
nearest Waste Management Plant at the end of its servicable life.
26