Putting The Prcd Switch Into Operation; Function Of The Unit; Overview (A); Start Of Operation (B) - Rothenberger RODIADRILL 160 Instrucciones De Uso

- Never use the electric tool without a PRCD.
- The plug or electrical cord should be replaced only by the manufacturer of the electric tool or
by its repair service.
- Keep water away from electrical parts of the electric tool and from people in the work area.
3.1

Putting the PRCD switch into operation

Only suitable for AC current! Note the mains network voltage!
Perform the following test procedure on the PRCD switch before every putting into operation of
the device:
1. Connect the PRCD plug connector with the socket.
2. Press on RESET. The indicator switches to ON.
3. Pull the plug connector out of the socket. The display switches itself off.
4. Repeat 1. and 2.
5. Press on TEST. The indicator switches itself off.
6. Press on RESET to switch the device on.
These protective device protect against faults in the attached device, not against
such faults in the preceding plant!
4

Function of the Unit

4.1 Overview
Drill rig fitting
1
Overload protection indicator
2
Power cable with PRCD switch
3
On/off switch
4
Gear selector switch
5
4.2 Start of operation
Freehand operation
 Only work with the moment switch, i.e. without locking the on/off switch.
 The additional hand grip (9) can be fasted on the left or on the right.
Great moments of force are generated when drilling using drill bits; never work without
the additional hand grip.
Clamping into the drill rig (picture 1)
 Locate the feed gear in position on the drill rig.
 RODIACUT 150: Insert the motor into the receptacle of the drill rig from the top and fasten
by means of the screws (size 6 Allen key).
 RODIACUT 250: Slide the motor from the top as far as it will go stop into the feed unit of the
drill rig and tighten using both star handles.
 Check the tight fit of the motor.
For this please read the drill rig instruction manual!
Changing the drill bit (picture 2)
Please wear protective gloves when changing the drill bit. The drill can become hot after
being in use for a longer period of time.
 Use an open-ended spanner (SW 36) to hold the drive shaft (8) and release and unscrew
(right-hand thread) the drill bit using an open-ended spanner (SW 24 for G 1/2" bits; SW 41
for 1.1/4" UNC bits).
Information: In the case of drill bits with a 1.1/4" UNC screw thread it is recommended to place
a copper ring (No. FF35190) between the drill motor and the drill bit. It is then easier to separate
14
Water connection
6
"Gardena" water connection
7
Drive shaft
8
Hand grip
9
ENGLISH
(A)
(B)