Tabla de contenido
Excessive build-up of frost inside the
freezer compartment.
Reversible door
∙ If required, the door may be reversed, i.e. from right-hinged
(default installation) to left.
∙ To avoid the risk of personal injury or damage to the unit,
two people are needed to reverse the door.
∙ Warning: Always disconnect the unit from the mains before
any maintenance or repair work is carried out.
∙ Before you start, please note the following:
∙ Always ensure that the correct number of washers is used
on all hinge bolts and screws.
∙ So that the doors can close tightly against the frame, take
the utmost care that they are properly aligned during re-
assembly.
1.
Remove the four covers C from the housing and inside of
the door.
2.
Unscrew the hinge bolt on the inside of the door in the
area C/6. Caution: Support the door.
3.
Take off the refrigerator door.
4.
Take out the fi xing screws and remove the upper bracket
6. Note the small plastic plate underneath the bracket.
5.
Turn the bracket 6 including the small plastic plate through
180° and replace it on the other side of the refrigerator,
using the two screw holes adjacent to each other.
18
All manuals and user guides at all-guides.com
∙ It is necessary to de-frost the freezer compartment manually. → See 'De-frosting and
cleaning'
∙ See 'Excessive build-up of frost on the rear of the main cabinet' (above).
6.
7.
8.
9.
10. Take out the fi xing screws and remove the bracket 2 with
11. Unscrew the hinge bolt, together with the washers, from
12. Remove the bracket 7 and replace it with the holding
13. Now install the holding bracket 7 in the previous position
14. Take out the sealing plugs 8 from the partition separating
15. Take out sealing plugs 9 from the freezer door and replace
16. Place the freezer door onto the hinge bolt on holding
Place the refrigerator door on a soft surface. Remove the
hinge support 5 from the underside of the door and fi t the
hinge support provided on the opposite side.
Take out the covering caps and then remove the hinge
support in the middle 4. Note the small plastic plate
underneath the bracket. Caution: Support the door.
Take off the freezer door 3.
Remove the lower panel 1 by lifting it up slightly.
its hinge bolt. Note the small plastic plate underneath the
bracket.
the bracket, and fi t it into the corresponding opening on
the opposite side of the bracket.
bracket 2 with its hinge bolt.
of the bracket 2.
the refrigeration and freezer compartments and replace
them in the openings on the opposite side.
it in the opening on the opposite side.
Tabla de contenido
