Sears Craftman 900.74828 Manual Del Operador página 6

ASSEMBLY FOR VACUUM
MODE
SHOULDER COLLECTION BAG
(FIGURE 5)
• Attach the shoulder collection bag to the
power head as shown in figure 5.
5
VACUUM TUBE ASSEMBLY
(FIGURES 6-10)
• Vacuum tubes must be assembled
together before use.
• Align the notches and the triangles on
upper and lower tubes. (figure 6)
6
• Push the lower tube firmly into the upper
tube, until the triangles click into place.
(Never operate apart).
• In the interest of safety, it is not intended
for the tubes to be separated once
assembled.
• To attach the rake to the vacuum tube,
slide the rake over the flat end of the
vacuum tube opening as shown in figure
7. The "wings" of the rake must go under
the lip of the flat portion of the tube.
Continue to slide the rake toward the end
of the tube until you hear it "click" into place.
All manuals and user guides at all-guides.com
7
• To remove the rake from the vacuum
tube, lift up on the catch as shown in
figure 8 and pull the rake backwards to
release.
8
• Remove the fan cover grill from the
bottom of the power head by pressing the
spring loaded release button (located on
the back of the power head) and pulling
the cover off (figure 9).
9
• Attach the vacuum tube assembly to the
power head (figure 10) by locating the
assembly as indicated by arrow, then
pivot about this point until the
locking/release catch is fully engaged.
6
Wings