Idiomas disponibles
Idiomas disponibles
SAFETY WARNINGS AND INSTRUCTIONS:
To reduce the risk of electric shock, this
equipment has a polarized plug (one
blade is wider than the other). This
equipment must be used with a suitable
polarized 2 wire or 3 wire extension cord.
Polarized connections will fit together
only one way. Make sure that the
receptacle end of the extension cord has
large and small blade slot widths. If the
plug does not fit fully into the extension
ASSEMBLY INSTRUCTIONS
ASSEMBLY FOR BLOW MODE
WARNING: Before attempting any of
the assembly steps below, ensure
product is switched off and disconnected
from the power supply.
BLOW TUBE ASSEMBLY (FIGURES 1-4)
• Ensure fan cover grill is attached to the
power head. If not, attach cover as
shown in the inset of figure 1. NOTE:
Unit will not operate in blow mode without
fan cover grill in place. Align the upper
and lower tubes as shown in figure 1.
1
• Push the lower tube firmly into the upper
tube, until the tubes click into place.
• Blow tubes must be assembled to the
power head before use.
• Never operate without both lower and
upper tubes assembled.
• In the interest of safety, it is not intended
for the tubes to be separated once
assembled.
All manuals and user guides at all-guides.com
POLARIZED PLUGS
cord, reverse the plug. If it still does not
fit, obtain a suitable extension cord. If the
extension cord does not fit fully into the
outlet, contact a qualified electrician to
install the proper outlet. Do not change
the tool plug or extension cord in any
way.
SAVE THESE INSTRUCTIONS
FOR FUTURE USE
• Push the tube assembly onto the power
head until it is in the fully locked position
(figure 2).
2
• Use the air concentrator attachment to
target air flow to a tighter area. Add the
attachment to the assembly as shown in
figure 3. Push on until hole in tab
engages raised post on tube.
3
• Use the turbo nozzle attachment to
rapidly move air back and forth to
remove stubborn debris from grassy
areas. Add the tube to the assembly as
shown in figure 4. Push on until hole in
tab engages raised post on tube. To lock
the turbo nozzle attachment and reduce
the back and forth motion, push forward on
the locking tab.
4
5
