Cisco 500 Serie Guia De Inicio Rapido página 10

Make sure that any configuration changes are saved before
C
AUTION
exiting by issuing the command:
copy running-config startup-config
You are ready to configure the switch. Refer to the
Stackable Managed Switch Administration Guide for further information.
If you are not using DHCP on your network, set the IP address type
N OTE
on the switch to Static and change the static IP address and subnet
mask to match your network topology. Failure to do so may result in
multiple switches using the same factory default IP address of
192.168.1.254.
Stacking the Switches
Before configuring the switches as a stack, refer to the Cisco 500 Series
Stackable Managed Switch Administration Guide for additional details.
Refer to the front panel graphics in
Series Stackable Managed Switch, page 16
descriptions and supported modules.
The following graphic shows the stack ports to assist in connecting the
devices in a stack:
Cisco Small Business
LINK
ACT XG
XG1 XG2 XG3 XG4
/S1 /S2
The 500X model is on the left, and the Sx500 model is on the right. The
SG500XG-8F8T model is shown below.
LINK
ACT XG
9 10 11
10
All manuals and user guides at all-guides.com
External Features of the Cisco 500
to help with the stack port
LINK/ACT GIGABIT
5G
G25/S1 G26/S2
Stack
LINK
ACT XG
12 13 14
500 Series Stackable Managed Switches
Cisco 500 Series
Cisco Small Business
LINK
ACT
LINK
ACT
SFP G27/S3 G28/S4
1G/5G
LINK/ACT GIGABIT
15 16
G1