Care; Replacement; Replacing The Belt - Yamaha MusicCast VINYL 500 Manual De Instrucciones

|
When necessary

Care

Care
 Caring for this unit
Wipe it with a soft dry cloth. Do not use chemicals such as benzine or thinner,
since they might damage the surface.
 Caring for the record stylus
The tip of the record stylus is extremely delicate. Handle it with care so that it is
not damaged. If dust should adhere to the tip of the stylus, use a soft pointed
brush to wipe it off starting at the base of the stylus and moving toward the tip,
or use a commercially available cleaner made for that purpose.
 Caring for records
Dirt adhering to a record can cause skips or noise. Use a commercially available
record cleaner to remove dirt.
36
En

Replacement

Replacing the belt

Depending on the conditions of use, the belt can wear out or break. If this
occurs, replace the belt. For a replacement belt, contact your nearest
authorized Yamaha dealer or service center.
1
Turn off the power of this unit and of the connected devices, and
disconnect this unit's AC adaptor from the AC outlet.
2
Remove the platter sheet from the platter.
3
Detach the belt from the pulley.
4
Insert your fingers into the round holes of the platter, and lift up the
platter.
CAUTION

Take care not to drop the platter. Dropping it might cause injury,
or might damage the unit.
5
Turn the platter over, and remove the belt.
6
Install the replacement belt on the platter.
Take care that the belt is not twisted.
7
Install the platter on this unit.
For details on installation, refer to "Assembly" on page 15.