Uline H-7181 Manual Del Usuario página 3

4. Determine desired tray location and mark a line
1" above the bottom edge of board. Drill two 5/16"
diameter holes in wall 5⁄" apart.
5. Push in two plastic anchors into predrilled holes. Place
tray mount over plastic anchors and secure with two
CS screws. (See Figure 4)
Figure 4
Bottom
of Board
Tray Mount
CS Screw
6. Place aluminum tray in the front slot of tray mount
and align the holes. Secure aluminum tray to tray
mount using two Phillips tray screws. (See Figure 5)
Figure 5
Aluminum Tray
Phillips Tray Screw
7. Measure down 3/4" from the top line and draw
another line that is parallel. Measure in about 6"
from each side and install top three wall mount
brackets using three CS screws. (See Figure 6)
NOTE: Leave the top wall mount brackets
pushed up.
Figure 6
Top Edge
6"
PAGE 3 OF 9
INSTALLATION CONTINUED
Wall
Tray
Mount
5⁄"
Line
Plastic
Anchor
Line for
Board Mounts
Tray Mount
Wall
CS
Mount
Screw
3/4"
Bracket
8. Apply self-adhesive pads to back of board. Peel
one side of the backer from the pad and apply to
the board as shown. (See Figure 7) Then peel the
other side before mounting on the wall. Carefully
position the panel left to right before applying
pressure against the wall.
Figure 7
9. Place the glass board on bottom wall mount brackets
and screw in the three wall mount bracket outer caps
to secure. Tilt the glass board back and push down
the top wall mount brackets onto the board's top
edge. Secure board in place by screwing in the three
top wall mount bracket outer caps. (See Figure 8)
Figure 8
1-800-295-5510
uline.com
Center
12"
12"
Self-Adhesive
Pads
Vertical Mount
Self-Adhesive
Pads
18"
Horizontal
Center
Mount
Wall Mount Bracket
Outer Cap
Glass
Board
Wall Mount Bracket
Outer Cap
18"
Wall Mount
Bracket
Wall Mount
Bracket
0621 IH-7181