Warning Indicators; Technical Specification - Salter 9106 Instrucciones De Empleo

WEIGHT & BODY FAT READINGS
Position the scale on a flat level surface.
1) Press the SET button.
2) Select your user number by pressing the L or M buttons.
3) WAIT while the display reconfirms your personal data then
shows a zero reading.
4) When zero is displayed,WITH BARE FEET, step onto the
platform and stand still. Ensure your feet are in good contact
with the 4 metal pads on the platform.
5) After 2-3 seconds, your weight will be displayed followed by
your body fat percentage, bone mass, total body water
percentage and muscle mass percentage.
Note:
When the body fat reading is displayed a horizontal bar will appear
above the body fat reading.This corresponds to the low, normal and
high printed above the display.This gives a general guide to your
body fat category - low, normal or high.Also refer to the normal
body fat tables on page 3.
Tip: Instead of steps 1 & 2 you can select your user number as follows:
Press and hold the platform with your foot. After 2 seconds the
user number will appear in the centre of the display and begin to
cycle. Release your foot when your user number is displayed.
6
All manuals and user guides at all-guides.com
Weight
Body Fat
BODY FAT
CATEGORY
INDICATOR
Bone Mass
Body Water
Muscle Mass
WEIGHT READING ONLY
Position the scale on a flat level surface.
a) Press the centre of b) When '8888' appears,
the platform firmly to remove foot from
activate the scale. platform and WAIT
for display to show
a zero reading.

WARNING INDICATORS

'Lo' = replace battery.
'Err1' = overload.

TECHNICAL SPECIFICATION

100 cm - 220 cm
3'3" - 7'2"
16 - 80 years
Male/Female/Athlete
10 user memory
c) When zero is d) After 2-3 seconds,
displayed, step onto your weight will
the platform and be displayed.
stand still.
'Err2' = out of body
fat range or poor
feet contact.
d = 0.1 % body fat
d = 0.1 % body water
d = 0.1 % muscle mass
d = 0.1kg / 0.2lb bone mass
7