Before Returning For Repairs; Specifications - Schumacher Electric SI-200A Manual Para El Propietario

PROBLEM
The battery is connected
and the charger is on, but is
not charging.
The measured current is
much lower than what was
selected.
17.

BEFORE RETURNING FOR REPAIRS

17.1 When a charging problem arises, make certain that the battery is capable of
accepting a normal charge. Double check all connections, the AC outlet for the
correct voltage, the charger connectors for correct polarity and the quality of
the connections from the cables to the connectors and from the connectors to
the battery system. The connectors must be clean.
17.2 When a battery is very cold, partially charged or sulfated, it will not draw
the full rated amperes from the charger. It is both dangerous and damaging
to a battery to force higher amperage into it than it can effectively use in
recharging.
17.3 When an UNKNOWN OPERATING PROBLEM arises, please read the
complete manual and call the customer service number for information that will
usually eliminate the need for return.
Schumacher and the Schumacher Logo are registered trademarks of
18.

SPECIFICATIONS

Data Plate
Single Phase Power Supply (Vac)
Frequency (Hz)
Charging Voltage(s) (V)
Effective Charging Current, Continuous (A)
Max. Power Absorbed Charge/Start (KW)
Dimensions (mm)
Weight (Kg)
Output Protection
Reverse Polarity Protection
Spark/Arc Proof
1. Microprocessor controlled, relay protected output.
All manuals and user guides at all-guides.com
POSSIBLE CAUSE
Connectors are not making
a good connection.
The charger reached the
maximum voltage and is
reducing the current.
Schumacher Electric Corporation
45
• •
REASON/SOLUTION
Check for poor connection
at battery and frame. Make
sure connecting points are
clean. Rock connectors
back and forth for a better
connection.
No problem, this is a normal
condition.
120V, 50/60Hz 230V, 50/60Hz
100 - 250 100 - 250
50/60 50/60
12
2
0.0587 0.0587
188 x 84 x 72 188 x 84 x 72
0.54
Yes
1
Yes
1
Yes
1
12
2
0.54
Yes
1
Yes
1
Yes
1