Waring Commercial CB15V Manual Del Usuario página 4

4. Press the green POwER
button to turn on the
blender. Green LED will
illuminate and remain steady.
Select the desired speed
with the variable speed
control knob. Press the red
START/STOP button to begin blending. You may
change the speed with the variable speed control knob
anytime during blending. When finished blending, press
START/STOP button. For momentary operation, press
the grey PULSE button; motor will run on HIGH speed
until the button is released. The Green LED will blink
during operation.
5. Always hold container with one hand when starting
and while blending. Never operate without container lid
properly clamped in place.
6. Allow motor to come to a complete stop before
removing container. Never place the container on the
motor base or remove it from the motor base while the
motor is running.
7. P ress the POWER button again to turn off the blender.
8. Remove the container from the motor base and empty
the contents.
9. Wash and dry container after each use. See separate
Cleaning & Sanitizing Instructions for All waring
Blenders.
10. Not for waterjet Cleaning.
11. The use of ear protection is recommended during
extended operating periods.
TO REALIZE MAXIMUM SERVICE LIFE, OBSERVE THE
FOLLOwING PRECAUTIONS:
1. Do not lubricate container bearing, drive shaft, or shaft
seals. These parts are lubricated and sealed at the
factory and do not require any further lubrication.
All manuals and user guides at all-guides.com
6
2. Reduce amounts of material processed to less than the
full 4-liter capacity when working with viscous or fibrous
materials.
3. When cleaning exterior of container, keep it in normal
upright operating position to prevent liquids from running
into the bearing through the bottom end.
HOT BLENDING INSTRUCTIONS: IMPORTANT!
To minimize the possibility of scalding when blending hot
materials, the following precautions and procedures must be
observed:
• Hot materials are those which are 100˚F (38˚C) or hotter.
• A lways start blending on lowest speed setting, then
progress to desired speed.
• N ever stand directly over blender when it is being started
or while it is running.
• C onstant monitoring of the condition of the container lid
gasket and the container lid clamps is mandatory. Replace
these parts if they become worn or loose, or are damaged
in any way.
MAINTENANCE
Motor - Not for Waterjet Cleaning.
The Waring Commercial Blender ball bearing motor requires
no greasing or oiling. Sealed-in lubrication provides smooth
unit operation.
Container - The stainless steel container can be sterilized
without injury to the bearing.
Container pad to be washed and rinsed in solutions noted in
Cleaning and Sanitizing Instructions.
Depending on the operating conditions, service life of the
main components of the container blade assembly, socket
head shaft and shaft seals is 500 hours actual running time.
7