Tabla de contenido
Idiomas disponibles
Idiomas disponibles
For your own safety
Before
using
the
steam
cleaner,
ways read the
operating
structions and keep them read-
ily available.
The cleaner should only be used
by persons acquainted with its
use.
The cleaner should not be used
by children.
CAUTION:
Risk of burns and scalds.
Metal parts, water and hot steam
can cause severe burns.
Avoid contact with hot cleaner
surfaces, emerging water and
steam.
The pressure tank is under pres-
sure during operation. For this
reason, never open the safety
catch during operation.
Be careful particularly during the
following work as there may still
be hot steam in the cleaner:
– Opening the safety catch.
The safety catch has a pres-
sure relief hole. Open the
safety catch by one or two
turns. Wait until no steam
emerges. Then completely
open the safety catch.
– Refilling the boiler
– Emptying the boiler
The use of the steam cleaner is
subject to valid national regula-
tions. Besides the operating
instructions and the binding
accident prevention regulations
valid in the country of use, ob-
serve recognized regulations for
safety and proper use.
Do not use any unsafe work
techniques.
All manuals and user guides at all-guides.com
Before start-up
Before starting up the cleaner,
check that it is in proper condi-
tion.
al-
Do not switch the cleaner on if
in-
there is no water in the boiler.
Do not start the cleaner near ex-
plosive and/or easily flammable
substances.
Use only tap water or distilled
water to fill the boiler. Distilled
water extends the service life
of the cleaner. Cleaning agents,
scents,
solvents
chemical substances may dam-
age the cleaner and may be a
risk to health.
Regularly check whether the
steam hose and power cord
are damaged or show signs of
age. Only use the cleaner if the
steam hose and power cord are
intact.
Check the rated voltage of
the steam cleaner before con-
necting it to the mains supply
system. Ensure that the voltage
shown on the rating plate cor-
responds to the voltage of the
local mains power supply.
Never touch the plug and electri-
cal cables with wet hands.
It is recommended that the
steam cleaner should be con-
nected via a residual current
circuit breaker. This stops the
supply of electricity if the leak-
age current to earth exceeds 30
mA for 30 ms or it has an earth
tester circuit.
During use
Never leave the cleaner unsu-
pervised when it is connected.
Never turn the cleaner over or tilt
it while it is in operation.
Never use the cleaner when
other people are nearby.
Place the cleaner as far away
as possible from the object to
be cleaned.
Do not leave the cleaner near to
sources of heat (fire, radiators,
heating fans or other equipment
that radiates heat) and never
cover the cleaner.
The steam jet can be dangerous
if it is misused. Never direct the
jet on to persons, animals, elec-
trically powered equipment or
the cleaner itself.
Remove condensed water from
and
other
the nozzle before starting up
the cleaner and after every work
break. To clean the nozzle, di-
rect the steam jet into a tank or
sink and actuate the steam lever
on the steam gun. After cleaning
the nozzle you can begin work
again as normal.
CAUTION:
Materials containing asbestos
and other hazardous substanc-
es should not be cleaned.
Do not use the steam jet to clean
switches, sockets, controllers,
etc. and other electrical parts on
electrical cleaners.
Make sure that the child-proof
lock is actuated on the handle
during work breaks.
To prevent the cleaner from
being used inadvertently dur-
ing work breaks, switch off the
cleaner and pull out the mains
plug.
Allow the cleaner to cool down
completely before storing it or
opening the safety catch.
Store the cleaner in a dry place.
CAUTION!
Unsuitable extension cords can
represent a source of danger.
Always unwind cord from the
reels completely to prevent the
power cord overheating.
STEAMTEC 520
english
1
Tabla de contenido
