Setting The Cutting Height - Cub Cadet 17AIEACI603 Instrucciones De Funcionamiento Originales

Operation
Switching the cutter deck on/off
(depending on the model)
The PTO switch actuates an mechanical clutch to
switch ON and OFF the cutters.
To switch the cutter deck on, pull the PTO switch
.
.

Setting the cutting height

The cutter deck has a height adjustment mechanism
with multiple settings.
The cutting height range for mowing is between
about 2.5 cm for the lowest cutting height (index
1 on the height-adjustment start knob [N]) and
11.4 cm for the highest cutting height (notch
index 4.5).
Note
Each index setting (maximum 15 setting
options - dependent on the model) shifts the
cutter deck by about 6.4 mm.
Note
The highest cutting height (index 4.5) should
ing).
Step fully down on the pedal for the cutter deck
height adjustment [A] to move the cutter deck to
the fully raised position.
Rotate the height adjustment star knob [N] to the
desired cutting height (index 1 to 4.5).
Slowly remove your foot from the cutter deck
lifting pedal.
The cutter deck drops slowly to the selected
height and is locked down in this position.
Mowing
CAUTION!
Risk of injury
Only empty the grass catcher when the
Only operate the device with the
If a foreign object (like a stone) comes into
contact with the cutting mechanism, or if the
device starts to vibrate unusually, switch the
Inspect the device for damage before continuing
operation. In the event of damage, discontinue
use of the device and have it repaired by
a service centre prior to putting back into
operation.
Do not activate the cutter deck in high grass.
Note
with the cutter deck switched on if absolutely
necessary.
so the cut grass is thrown out sideways into the
middle.
Do not allow the grass to grow too long, and never
cut it too short.
Drive in straight lines an do not mow at high speed,
particularly when a mulching kit or grass catcher is
-
installed.
Sit down on the driver's seat.
Bring the cutter deck to the top height position.
Start the engine as indicated.
Set the throttle to
Switch the cutter deck on and then lower it.
Release the parking brake by pulling both control
levers into the neutral position.
To drive away, press both control levers forwards
slowly and evenly. The further they are pressed
forwards, the faster the device moves.
Information on mowing
maximum engine speed. When adjusting the
order to be able to collect grass with a grass
catcher without any trouble.
Information on mowing
raise the cutting height.
Attention!
.
EN
-
19