Symphony™ Ii Power Monitor (Optional); Status Led's - Briggs & Stratton Dual 200 Amp Manual Del Usuario

Symphony™ II Power Monitor (Optional)
For your convenience, a Symphony II Power Monitor is available,
which provides a visual "on/off" status of each managed appliance/
load. A series of LED lights are ON when an appliance has
generator power and OFF when the appliance is in a removal mode
or does not have power. When on generator power, the consumer
can see which appliances are being managed.
A decal is provided that can be labeled with the managed
appliances/loads and placed next to each priority LED.
The monitor is plugged into any convenient standard outlet that will
receive generator power within the building and constantly receives
system status via the power line communication technology utilized
by the Symphony II Power Management System during generator
power.
A
B
C
POWER LIGHT (A)
When lit, indicates that monitor
detects outlet power.
When not lit, indicates that no
power is present at outlet.
COMM (communication status)
LIGHT (B)
When lit, indicates that unit
is receiving signals from the
Symphony II controller.
When not lit, indicates that utility
power is present, or possibly
power line noise causing a
communication issue, or a fault
in Symphony II controller.
PRIORITY LIGHTS/LED's (C)
When green LED is lit, indicates that optional remote module set to
that priority is supplying power to connected load during generator
power.
When not lit, indicates that optional remote module set to that
priority is set to OFF (being managed and Symphony II System is
not allowing power to the unit).
All lights/LED's are OFF when utility power is present.
20

Status LED's

Described below are the system's LED indicators and the conditions
each LED color represents:
Transfer Switch Control Board
STATUS LED
RED (D) means GENERATOR power is present.
J6
GREEN (E) means UTILITY power is present.
J5
J4
Symphony II System Control Board
J3
J2
J1
STATUS LED (F)
Single Blink-Pause means unit is operating on GENERATOR power.
Double Blink–Pause means unit is operating on UTILITY power.
PRIORITY LIGHTS/LED's (C & G)
When green LED is lit, indicates that optional remote module set to
that priority is supplying power to connected load during generator
power.
When not lit, indicates that optional remote module set to that
priority is set to OFF (being managed and Symphony II System is
not allowing power to the unit).
All lights/LED's are OFF when utility power is present.
312113
D E
F G
BRIGGSandSTRATTON.COM