Transport And Storage - Hilti NURON C 6-22 Manual De Instrucciones Original

7. Seat the supply cord in the cable guide exactly as the original cable
was routed prior to replacement. Use the photo taken beforehand or the
sketch you drew as reference.
8. Flip the cover closed and re-install the securing screw.
9. Push the rubberized foot back into the cover.
10. Plug the supply cord into a power outlet and check that the charger is in
full working order.
▶ LED shows: Charger is in full working order.
▶ LED does not light up: Charger is not in full working order.
▶ Contact Hilti Service.
7

Transport and storage

Transport
▶ Make sure that the equipment is held securely throughout all transport
operations.
▶ After transporting, always check all visible parts and controls for signs of
damage and make sure that they all function correctly.
Storage
▶ Always store this product with the electric supply cable unplugged from
the electricity supply.
▶ Store this product in a dry place, where it cannot be accessed by children
or unauthorized persons.
▶ After a long period of storage, always check all visible parts and controls
for signs of damage and make sure that they all function correctly.
8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, contact Hilti Service.
Malfunction
LED doesn't light.
*2275224*
Possible cause
Supply cord not con-
nected to electricity sup-
ply.
Product malfunction.
Supply cord faulty.
The charger is defective. ▶ Have the product
2275224
Action to be taken
▶ Plug the supply cord
into the power outlet.
▶ Unplug the product
and then plug it
back in. If the LED
remains off, consult
Hilti Service.
▶ Replace the supply
cord. → page 20
repaired by Hilti
Service.
English 21