Troubleshooting - Ryobi YG250FS Manual Del Operador

PROBLEM
Air leak near the top of the tool or in the
trigger area
Air leak near the bottom of the tool
Tool does nothing or operates sluggishly Inadequate air supply
Tool jams frequently
NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 14 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.

TROUBLESHOOTING

POSSIBLE CAUSE
Loose screws
Worn or damaged O-rings or seals
Worn or damaged O-rings or bumper
Worn or damaged O-rings or bumper
Incorrect fasteners
Damaged fasteners
Loose magazine
Dirty magazine
Worn or damaged driver
12 — English
SOLUTION
Tighten screws
Install Overhaul Kit
Install Overhaul Kit
Verify adequate air supply
Install Overhaul Kit
Verify that fasteners are the correct size
Replace fasteners
Tighten screws
Clean magazine
Install Driver Maintenance Kit