Digitus DN-170093 Guía Rápida De Instalación página 8

UP
DOWN
UP + DOWN
3.2 UPS startup and turn off
• Startup operation
(1) Turn on the UPS in line mode
Note: Verify that the total equipment ratings do not exceed the UPS capacity to
prevent an overload alarm.
a) Once mains power is plugged in, the UPS will charge the battery, at the
moment, the LCD shows that the output voltage is 220, which means the UPS
automatic ally tart the inverter. If it is expected to change to bypassmodel,
you can Press "OFF" key.
b) Press and hold the ON key for more than three seconds to start the UPS, then
it will start the inverter.
c) Once started, the UPS will perform a self-test function, LED will light and go
out circularly and orderly. When the self-test finishes, it will come to line
mode, the corresponding LED lights, the UPS is working in line mode.
(2) Turn on the UPS by DC without mains power
a) When mains power is disconnected, press and hold the ON key for more
than half a second to start UPS.
b) The operation of the UPS in the process of start is almost the same as that
when mains power is in. After finishing the self-test, the corresponding LED
lights and the UPS is working in battery mode.
• Turn off operation
(1) Turn off the UPS in line mode
a) Press and hold the OFF key for more than half a second to turn off the UPS
and inverter.
b) After the UPS shutdown, the LEDs go out and there is no output. If output
is needed, you can set bps "ON" onthe LCD setting menu.
(2) Turn off the UPS by DC without mains power
• Up key: Press this button to display
previous selection in UPS setting
mode.
• Down key: Press this button to
display next selection in UPS setting
mode.
• To confirm selectionand exit setting
mode:Press this button to confirm
selection and exit setting mode
when LCD display the last selection
in UPS setting mode.
• Setting mode: Press and hold this
button for 5 seconds to enter UPS
setting mode.
8