Axis Q1775-E Guia De Instalacion página 13

LED Indicators
Note
The housing LED referred to in the table below is located in the housing.
Housing LED
(fan and heater)
Green
Flashing green
Status LED Behavior and Buzzer Signal for Levelling Assistant
For information on using the control button to start levelling of the camera, see page 15.
Color
Fixed green
Flashing green
Flashing orange
Flashing red
Connectors and Buttons
For specifications and operating conditions, see page 15.
Network Connector
NO TICE TICE
NO NO TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2.
AXIS Q1775-E Network Camera
Indication
Normal operation.
Single flash: Heater error
Double flash: Fan error
Triple flash: General error
Alarm events will be triggered through the camera's input port.
Contact your Axis reseller for information about spare parts and
troubleshooting.
Buzzer
Continuous beep
Fast interval
Medium interval
Slow interval
Camera position
Level
Almost level
Not level
Far from level
13