Fault codes
If there is a fault, the oven will beep every second, and a fault code will appear in the clock
display as a letter 'F' with a number after it.
Important!
Do not turn off the main power supply to the oven if you get a fault code. The fans are needed to cool the
oven.
For safety, this oven is designed to self-cool. Turning off the power while the oven is hot may damage the
oven and its surrounding cabinetry.
If you get a fault code:
Note the fault code.
1
Turn the temperature and oven mode knobs to OFF.
2
PUSH TO
Press the
3
CLEAR
enough to clear the fault.
Call your DCS Authorized Service Center with the fault code information.
4
Note: if your are unable to immediately clear the fault code or contact your DCS Authorized
Service Center, wait for the oven cooling fans to stop, and then press the
again. It is likely that the oven will now clear the fault. If it does not, then you may turn the oven
off at the wall once the fans have stopped and the oven has completely cooled down.
Troubleshooting
Problem
Oven does not
work
button. The oven may have already self-corrected, and this will be
Possible cause
Power supply is not
connected.
Clock is not set due to
power cut or failure.
Oven door is open.
Troubleshooting
PUSH TO
What to do
Have a service company/electrician
check power connections, wiring and
fuses.
You must set the clock before you can
use the oven. The oven will go into
'Set Up' mode when the electricity is
restored after a power cut. The oven
mode and temperature displays will
show OFF. Both displays will be unlit
and unresponsive. The colon (:) in the
clock display will flash. See 'Setting the
clock' .
The elements are disabled by the door
switch when the door is open. Make
sure the door is properly closed.
37
button
CLEAR
US CA