Hoover DDY 65543FAM Instrucciones Para El Uso página 16

Memorization of the last
programme used
The last programme
memorized by following the below:
IMPORTANT
The dishwasher must ALWAYS be off
before start of this procedure.
1. Hold down
SELECTION" button and at the same
time switch on the dishwasher by
pressing the "ON/OFF" button (a brief
audible signal will sound).
2. Keep the "PROGRAMME SELECTION"
button pressed for at least 30 seconds
(during this time, 3 audible signals will
sound).
3. Release the button when the THIRD
audible signal sounds ("A0 " will appear
on the display to indicate that the
memorization is off).
The dishwasher is able to signal a series of faults in the display.
AUTOMATIC FAULT SIGNALS
FAULTS
E2
appears on the display and
the alarm sounds.
E3
appears on the display and
the alarm sounds.
E4
appears on the display and
the alarm sounds.
E5,E6,E7,Ef EL
or
on the display and the alarm
sounds.
E8 Ei
or appear on the display
and the alarm sounds.
used can
the "PROGRAMME
No water (inlet hose closed).
The machine cannot drain water.
Water leak
Electronic control fault.
appears
The water heating element is not
working correctly or the filter plate is
clogged.
4. Press the same button again ("A1" will
appear on the display to indicate that the
memorization is on).
be
5. Turn off the dishwasher by pressing the
"ON/OFF" button to confirm the new
setting.
To disable the memorization, follow the
same procedure.
IMPORTANT
This dishwasher is equipped with an
anti-overflow safety device which will
automatically discharge any excess
water should a problem occur.
WARNING!
To ensure the correct operation of
the anti-overflow safety device, we
recommend that the dishwasher is
not moved or tilted during operation.
If however it is necessary to tilt or
move the dishwasher, please ensure
that the washing cycle is complete
and that there is no remaining water
inside the dishwasher.
CAUSE
16
SOLUTION
Turn off the dishwasher, open the
inlet hose and reset the cycle.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Contact Customer Service.
Clean the filter plate.
If the problem persists, contact
Customer Service.