Cleaning The Guide Bar - Makita XCU07 Manual De Instrucciones

30
55
all cutters. Different cutter angles cause the chain
to run roughly and unevenly, accelerate wear, and
lead to chain breaks.
ening angle is kept against the teeth.
saw chains to sharpen the chain. Normal round
follows:
stroke.
of this shortest cutter becomes the standard for all
other cutters on the saw chain.
1
2
1. File 2. Saw chain
has markings for the correct sharpening angle of
30° (align the markings parallel to the saw chain)
and limits the depth of penetration (to 4/5 of the
30
55
—
-
-
—

Cleaning the guide bar

Chips and sawdust will build up in the guide bar groove.
Clean out the chips and sawdust every time when you
sharpen or replace the saw chain.
16 ENGLISH
30
1. File holder
After sharpening the chain, check the height of the
depth gauge using the chain gauge tool (optional
accessory).
Round off the front of the depth gauge again.
1
1/5