Remote Control - Domo DO-262A Manual De Instrucciones

DO-262A
- The appliance is making to much noise or is causing vibrations.
o
- Your appliance makes a gurgling sound
o

REMOTE CONTROL

GENERAL
- The remote control will only function within 8 m of the airco. Point the re-
mote in the direction of the airco. The transmission will be confirmed with a
beep signal.
- The airco will not react to the remote if the signal is blocked by curtains,
doors or other materials.
- Make sure the remote doesn't get wet. Don't expose the remote to direct sun-
light or heat.
- When the infrared sensor on the appliance is positioned in direct sunlight it is
possible that it won't react to the remote control. Make sure there is no direct
sunlight on the infrared sensor.
- When other electrical appliances are reacting to the remote control, remove
them further away from the airco or contact your supplier.
- Don't use old and new batteries at the same time in the remote control. Don't
use two different types of batteries in the remote control.
- Remove the batteries from the remote, when you won't use it for a longer
periode of time. (more than two months)
- Recycle used batteries correctly.
BATTERIES
The remote control works with 2 AAA (R03/LR3) batteries.
Remove the cover of the batterie compartment, by pressing down
on it and sliding it out of the remote.
Place the batteries, make sure to follow the indications + and –
indicated in the batterie compartment.
Place the cover back on the batterie compartment.
NOTE : When removing the batteries all selections will be deleted.
When placing new batteries you have to reinstall all the selections.
The floor is nog level or flat. Place the appliance on the flat and level
surface if possible.
The sound is produced by the refrigerant in your appliance, this is
normal.
62