Oki IP-7900-26 Guía De Consulta Rápida página 10

17
This sign is di splayed when the slack is
insufficient.
- In case of use of sheet media, this message is not
displayed.
- If the media slackness is insufficient, the next
operation will not be started.
C H E C K
S L A C K E N M E D I A
18
Press the tension bar to the peel roller's upper
part. Then create a slack between the platen
and the peel roller, by carrying the tension
bar to the rear side of the peel roller with a
supply-side feed switch.
Switch
Tension bar
Adjust the tension bar length and decide whether to
attach a flange or not, depending on the type and
width of the media.
Examples of tension bar combinations
Tension bar combination
Media
width TENSION winding mode
(inch)
IP-7900
36, 38
39, 44
45, 52
53, 60 M, S, S
61, 68
69, 76
77, 82
83, 94 L, M, S
95, 104 L, M, S, S
Tension bar
Other modes
IP-7900
S, S
M, S
L
L, S L(light)
L, M
L, S, S
Supply-side slack sensor
Slacken off to a level lower than the supply-side slack sensor.
When the slack reaches the sensor detection area, the
operation panel blips.
Note
- Be sure to rotate the panel with the supply-side feed switch.
Do not rotate the peel roller manually, or the printer may be
damaged.
19
Check the media setting.
Press the key.
S E T M E D I A
* O K ?
P R E P A R I N G M E D I A
P L E A S E W A I T
Note
- Rewind the printer's media completely at the end of the day. The
PVC media installed and left for a night on the printer may cause
media jam.
Peel roller
Scroller
9