Safety Instructions; Assembly - AL-KO solo 107 L-S Traducción Del Manual De Instrucciones Original

Safety instructions

Attachment cutting blade
Art. Nr. 127240
SAFETY INSTRUCTIONS
Use the machine only in perfect working or-
der.
Do not disable safety and protective devices.
The machine must not be operated with dif-
ferent cutting tools or attachments.
Wear appropriate working clothes:
Long trousers, sturdy footwear, gloves.
Safety helmet, safety goggles, ear de-
fenders.
Always ensure stability when working.
The machine must not be operated if the ope-
rator is under the influence of alcohol, drugs
or medication.
Always operate the appliance with two hands.
Keep the handles dry and clean.
Keep body and clothing away from cutting
parts.
Keep others away from dangerous areas.
Remove foreign objects from the working
area.
Always keep the guard, string head and en-
gine free of mowing debris.
Before leaving the equipment unattended:
Turn the engine off
Wait for the cutting unit to stop
Do not leave the appliance unsupervised.
Children and other persons who are unfami-
liar with the operating instructions must not
operate the machine
Before use, check that all screws, bolts and
nuts on the device are tight.
Insert the blade guard for ever, before they
transport the device or the knife or store.

ASSEMBLY

CAUTION!
The machine must not be put in opera-
tion before it has been assembled com-
pletely.
Mounting the "Loop" grip
see Figure 2
469706_b
Attachment string head
Art. Nr. 127234
1. Place the rubber sleeve (3) over the shaft.
2. Fasten the lower brace (2) and the center
piece (4) using the four Allen screws (1).
3. Place the grip rod (5) into the grip holder and
fasten with the upper brace (6) and the four
Allen screws (7).
Installing the safety cover
see Fig. 3
1 Place the brushcutter so that the work shaft
is pointing down.
2 Lift the stem tube and slide the guard (1)
along the bottom of the stem tube to the cor-
rect position (to the stop on the bevel gear).
3 Put down the stem tube with the guard.
4 First tighten the fixing part (2) using a screw
5 x 20 mm in hole (a) on the guard.
5 Then loosely tighten the second screw 5 x 20
mm in hole (b).
The fixing part (2) has a ridge inside for
hole (a). Therefore, the first screw can
immediately be tightened to the block
through hole (a) without the connection
being slanted
see Fig. 4 and 3
1 Now place the brushcutter so that the work
shaft is pointing up.
2 Tighten the guard and the fixing part using the
2 screws 5 x 35 through the holes on the re-
taining plate of the bevel gear. You may have
to correct the position of the guard because
the holes must align exactly on top of each
other.
3 Finally tighten the screw in hole (b).
Installing the cutting blade
see Fig. 5
1 Place the brushcutter so that the work shaft
is pointing up.
2 Place the cutting tool on the pressure fitting
(1).
The recess of the pressure fitting must fit
perfectly in the hole of the cutting blade
in order to centre the cutting blade.
19