EDM Product 08792 Manual De Instrucciones página 61

▶ When using the device in bodies of water with natural, muddy
ES
ground, set the device up at a slightly elevation position, e.g. on
bricks.
▶ Check whether the hose or pipe was attached properly.
▶ Make sure that the power cable (2) is not under tensile load and has
PT
enough clearance.
▶ Make sure that the mains connection corresponds to the specifica-
tions provided in the technical data.
EN
▶ Check the mains socket for its proper condition and sufficient
fusing.
▶ Make it impossible for moisture to reach mains plug or socket.
FR
THERE IS A RISK OF ELECTRIC SHOCK!
1. Fasten the supplied nylon cord to the transport
handle (1) at the top of the device. (see fig. 10)
2. Lower the device into the water at a slight angle
to allow any remaining air to escape. (see fig. 11)
fig. 10
Warning of electrical voltage
Electric shock from damaged power supply cable.
Make sure not to hold or suspend the device by the
power supply cable under any circumstances.
Note
At the bottom of ponds and other waterbodies deposits
may have accumulated over time. To prevent the
device from being damaged, do not lower it all the way
to the ground unless you are certain that the water is
clean, in other words that the size of the dirt particles in
the water does not exceed 5mm.
fig. 11
Instruction manual Ref. 08792