Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Troubleshooting Guide (cont.)
Symptoms
Recommended Action
B. Adjust the tank water level if it is too high.
C. Clean the valve inlet, valve head, or supply line.
Flush the lines.
D. An excessively high water supply pressure may
force the water through the fill valve. If required,
reduce external water pressure.
E. Foreign particles may be lodged under the float
valve seal. Clear particles from valve seat.
F.
The float valve seal may be cracked or split.
Replace valve assembly.
5.
The fill
A. Partially close the water supply shut-off valve if
cycle is
the water pressure to the toilet is too high. Check
noisy.
the toilet performance following any such
adjustment.
B. Remove dirt or obstructions from the valve head.
Flush the lines.
6.
Pump
A. The water line height may be incorrectly set. Set
draws air
the correct water line height. Adjust the screw
during
clockwise in order to raise the elevation of the
flush.
float and the full water line.
No flush.
A. The pump is not plugged in or the electrical
7.
The pump
power is not on. Plug the three-prong plug from
does not
the pump into Class A GFCI, or turn on power to
operate.
toilet.
B. The pump has locked out through its internal
thermal overload switch. Wait two minutes and
retry.
C. The trip button is not plugged in. Plug modular
plug of the trip button wire into jack in trip
button housing.
D. The trip button has failed. Replace the flush
button.
E. The pump has failed. Replace the pump.
8.
Circuit
A. Check that the circuit breaker is properly sized
breaker
and has no other electrical loads.
trips
frequently.
B. If the circuit breaker trips while the pump is
disconnected, have an electrician correct the fault
in the wiring to the toilet.
Kohler Co.
21
1057478-5-C
Tabla de contenido
