BGS technic 3336 Manual Del Usuario página 8

OVERVIEW
1 Clamping ring (chuck)
2 Counterholding ring (chuck)
3
Trigger
4 Air outlet
5 Compressed air inlet
OPERATING INSTRUCTION
Have the keyless chuck open by screwing counter-clockwise direction
by hand.
Insert a drill into the chuck and then tighten the keyless chuck at
clockwise direction by hand.
Make sure that the drill is tighten installed enough before operating the
tool.
WARNINGS: Only use drills that have an RPM rating equal to or
greater than the tool itself.
Remove the air cap from the tool air inlet and install the air inlet nipple.
Lubricate the tool before operating.
(See chapter "MAINTENANCE" section for oiling instructions.)
Connect the air supply hose to the tool.
Set the working pressure to 6.2 bar (90 psi).
Press the trigger, the tool starts to work (clockwise).
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
[email protected]
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed