Usb Power Port - Wagan Tech Power Dome NX 2485 Manual De Usuario

User's Manual—Read before using this equipment
7. Replace the Inverter dust covers and switch the Inverter Power Switch to the
OFF "O" position.
8. Recharge the Power Dome as soon as convenient.
DC POWER PORT
The DC Power Port (accessory socket) is located to the left of the Air Compressor
Hose Compartment. The port can power a DC load up to 11 Amps. Overloading
the port results in "tripping" the self-resetting circuit breaker. Removing the
overload automatically restores power to the DC power port.
1. Uncover the dust cover from the Power Port.
2. Turn the DC/USB Power Switch (next to the DC power port) to the ON "|"
position. Maker sure the LED next to the switch is lit.
3. Insert the 12V DC accessory plug into the Power Port.
4. Operate the appliance as usual.
5. After use, disconnect the accessory plug from the Power Port
and store the accessory.
6. Replace the Power Port's dust cover and switch the DC/USB Power Switch
to the OFF "O" position.
7. Recharge the Power Dome as soon as convenient.

USB POWER PORT

1. Uncover the dust cover from the Power Port.
2. Turn the DC/USB Power Switch (next to the DC power port) to the ON "|"
position. Maker sure the LED next to the switch is lit.
3. Insert the USB plug into the Power Port.
4. Operate the appliance as usual.
5. After use, disconnect the USB plug.
6. Replace the Power Port's dust cover and switch the DC/USB Power Switch
to the OFF "O" position.
7. Recharge the Power Dome as soon as convenient.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
©2013 Wagan Corporation. All Rights Reserved.
6