Mellerware GLIDE Manual De Instrucciones página 4

LABEL TYPE OF TEXTILE
Do not iron this article
Synthetics, Nylon, Acrylics,
•
Polyester, Rayon
•• Wool, Silk
••• Cotton, Linen
3.3.3. Insert the plug into the wall socket. The indicator
light will illuminate.
3.3.4. When the indicator light switches off you may
start ironing.
CAUTION:
to high temperature fabrics. Should you need to iron at
a low temperature, after using a high temperature you
must wait for the pilot light to illuminate again or you
will burn your clothes onto the iron. This will void the
warranty.
3.4. Dry ironing:
3.4.1. The iron can be used on the dry setting without
any water in the water tank, it is best to avoid having
the water tank full while dry ironing.
3.4.2. Turn the variable steam control to the minium
position.
3.4.3. Select the setting on the temperature control dial
best suited for the fabric to be used.
3.5. Steam Ironing:
3.5.1. Set the temperature control dial to the "••" or
"•••" position.
3.5.2. Set the variable steam control to the desired
position.
3.6.1. Select the minimum position (MIN) using the
thermostat control.
3.6.2. Unplug the appliance from the mains power
supply.
3.6.3. Remove the water from the water tank.
3.6.4. Clean the appliance as described in the cleaning
section.
23120_IM.indd 4
4. Cleaning
4.1. Disconnect the appliance from the mains power
supply and allow it to cool completely before undertak-
ing any cleaning task.
4.3. Clean the outer parts of the appliance with a damp
cloth with a few drops of washing-up liquid and then
dry. CAUTION! Do not immerse electrical parts of the
appliance in any liquid.
4.4. Do not use solvents, or products with an acid
or base pH such as bleach, or abrasive products, for
cleaning the appliance.
4.5. Never submerge the appliance in water or any
other liquid or place it under running water.
5. Anomalies and repair
5.1. Take the appliance to an authorised support centre
if product is damaged or other problems arise.
5.2. If the connection to the mains has been damaged,
it must be replaced and you should proceed as you
would in the case of damage.
05-Jul-17 11:05:14 AM