Use; Cleaning - Beurer FC 49 Instrucciones De Uso

8. Use

1. Moisten the FC 49 facial brush with water. Never use the device while it is dry, as this can irritate
the skin.
2. Apply the cleansing gel to your facial skin.
3. Press the ON/OFF button once to switch on the device. The LED light will briefly flash 3x and the
facial brush will begin to vibrate.
4. The device has a total of 15 intensity levels and when turned on, will begin to vibrate at a moderate
speed setting. To switch between the individual intensity levels, press the + / - button. The LED
light will briefly flash 3x each time the intensity level is changed.
5. Now apply the device gently to your face and cleanse your face using even movements. For cleans-
ing the delicate skin around the eyes, use a lower intensity level. The coarse cleansing surface can
be used for both cleansing oily skin, as well as massage.
6. After use, switch the device off by pressing the ON/OFF button once. The LED light will again flash
3x and the device will turn off.
7. Cleanse your face thoroughly with water to remove any residue from your skin.
8. Pat your face dry with a towel and then apply a moisturising cream using even, circular movements.
IMPORTANT
Stop use immediately if use of the facial brush leads to reactions, and consult your doctor.
Note
To ensure comfortable treatment, do not press the silicone nubs too firmly against the skin. Treat each
section of skin for a maximum of 20 seconds.
We recommend a daily cleansing routine of 1 minute mornings and evenings. To achieve an efficient
result, duration of use should not exceed 3 minutes. The facial brush switches off automatically af-
ter 15 minutes.

9. Cleaning

IMPORTANT
Never clean the device with cleaning products containing alcohol, petrol or acetone.
• Clean the device using only the methods specified.
• Thoroughly clean the device after every use. Clean the silicone nubs with soap and water. Afterwards
rinse off the soap residue with water.
• Pat dry the device with a lint-free cloth.
• Ensure that no water gets inside the charging socket. If this occurs, only charge the device once
the opening has fully dried.
19