Tabla de contenido
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp. 120° - 140° F*
Max. hot water temp
Flow rate - showerhead
Flow rate - handshower
* Please know and follow all applicable local plumb-
ing codes when setting the temperature on the water
heater.
Installation Considerations
• This showerpipe is for use with shower heads
rated at 2.5 GPM (9.5 l/min) or higher.
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• Make sure that the wall is strong enough to
support the showerpipe. Hansgrohe strongly
suggests installation of a header at the top
mounting point.
• The area where the top mounting piece is to be
installed must be flat and free of protruding grout
joints, etc.
This unit meets or exceeds the
following:
• ASME A112.18.1 / CSA B125.1
• Listed by IAPMO for use in the
US and Canada
2
15 - 75 PSI
145 PSI
176°F*
2.5 GPM max.
2.5 GPM max.
• The enclosed screws and anchors are suitable for
• This showerpipe requires showerpipe rough
• To prevent scald injury, the maximum output
• Keep this booklet and the receipt (or other proof
a solid surface wall. For other wall constructions,
select mounting hardware and reinforcement
suitable for that specific construction.
16181181(not included).
temperature of the shower valve must be no
higher than 120°F. In Massachusetts, the
maximum output temperature can be no higher
than 112°F.
of date and place of purchase) for this product
in a safe place. The receipt is required should it
be necessary to request warranty parts.
Tabla de contenido
