Operation; Important; General Instructions For Use - Beurer HT 80 Instrucciones De Uso

• Do not use the device on synthetic hair – risk of fi re!
Note
• Remove all packaging material before using the device.
• Only connect the device to a socket using the voltage specifi ed on the type plate.
• If you do not know the local mains voltage, request it from the relevant organisation.
• Only pull the mains cable from the socket by the mains plug.
• Do not use any additional parts that are not recommended by the manufacturer or off ered as accessories.
• Under no circumstances should you open or repair the device yourself, as faultless functionality can no
longer be guaranteed thereafter. Failure to comply will result in voiding of the warranty.
• In the event of a fault or damage, have the device repaired by a certifi ed specialist workshop.
• Never leave the device unattended during use.
• Do not use the device outside.
• If you pass on the device to someone else, make sure to also pass on these instructions for use.

6. Operation

Warning
• Position yourself on a dry, non-conductive surface. Risk of electric shock!
• Make sure that your hands are dry! There is a risk of electric shock!
• The heated brush [3], the curling brush [2] and the device may become very hot depending on the switch
setting and period of use – risk of burns and fi re! Do not touch the heated brush [3] or the curling brush [2].
• Place the device on fi reproof surfaces only. Risk of fi re!
• Ensure that no hair can be directly sucked into the device. Risk of fi re!

Important

• Do not jam the mains cable [11] in drawers or doors, for example.
• Untangle the mains cable [11] if it is twisted.
• Do not pull, twist or bend the mains cable [11] and do not pull or route it over/on sharp, pointed objects or
hot surfaces.
Note
A slight odour initially develops after switching on the device for the fi rst time. This is normal and not harmful
to your health. Allow the device to run for three to fi ve minutes. After that you can use the device as normal.
• For your safety, the device switches off automatically if it overheats.
• Pull the mains plug out of the socket and allow the device to cool down.
• Before switching the device back on, check the air outlet [4] and the air intake fi lter [8] for any blockages
(e.g. sucked-in fl uff , dust or hair).

6.1 General instructions for use

Step 1: Attaching/removing the brush attachment
To attach a brush attachment to the hot air brush, place the required brush
>
attachment on the hot air brush and carefully turn it right and left until you see
and hear it click in place.
To remove a brush attachment from the hot air brush, hold down the unlock
>
button [1] on the brush attachment and pull the attachment off the hot air
brush.
> Allow the heated brush [3] and the curling brush [2] to cool before you remove
them.
13