Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Intended use
Your Black & Decker strimmer has been designed for trimming
and finishing lawn edges and to cut grass in confined spaces.
This tool is intended for consumer use only.
Your Black & Decker charger has been designed for charging
Black & Decker batteries of the type supplied with this tool.
Safety instructions
General
@
Warning! When using battery-powered tools, basic
safety precautions, including the following, should
always be followed to reduce the risk of fire, leaking
batteries, personal injury and material damage.
Read all of this manual carefully before operating the tool.
Before operating the tool, make sure that you know how to
switch it off in an emergency.
The intended use is described in this manual. The use of
any accessory or attachment of performance of any operation
with this tool other than those recommended in this
instruction manual can present a risk of personal injury.
Retain this manual for future reference.
Work area
Do not expose the tool to rain.
Do not use the tool in damp or wet conditions.
Only use the tool in daylight or good artificial light.
Personal protection
Wear stout shoes or boots to protect your feet.
Do not operate the tool wearing open-toed sandals or
when barefoot.
Wear long trousers to protect your legs.
Using the tool
Stay alert. Watch what you are doing. Use common sense.
Do not operate the tool when you are tired.
If the tool begins to vibrate abnormally, switch it off.
Allow rotating parts to stop and inspect the tool for
damage and loose parts.
Safety of others
Do not allow children or any person unfamiliar with these
instructions to operate the appliance.
Do not allow children, visitors or animals to come near the
work area or to touch the tool.
Remember that the operator may be held responsible for
accidents or hazards occurring to other people or their
property.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play
with the appliance.
After use
Switch off and ensure that moving parts have stopped
rotating before leaving the tool unattended and before
changing, cleaning or inspecting any parts of the tool.
When not in use, the tool should be stored in a dry place.
Children should not have access to stored tools.
Inspection and repairs
Before use, check the tool for damaged or defective parts.
Check for misalignment and seizure of moving parts,
breakage or parts, damage to guards and switches and
any other conditions that can affect its operation.
Do not use the tool if any part is damaged or defective.
Do not use the tool if the switch does not turn it on and off.
Never use the tool when any guard or enclosure is
damaged or not in place.
Ensure that the tool operates properly and perform its
intended function.
Have any damaged of defective parts repaired or replaced
by an authorised repair agent.
Never attempt to remove or replace any parts other than
those specified in this manual.
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not expose the battery to heat.
Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
40 °C.
Charge only using the charger provided with the tool.
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Do not damage or deform the battery either by puncture or
impact, as this can create a risk of injury and fire.
Do not charge damaged batteries.
Chargers
Warning! Your charger has been designed for a specific
voltage. Always check that the mains voltage corresponds to
the voltage on the rating plate.
ENGLISH
5
Tabla de contenido
