Ec Declaration Of Conformity; Cooling Down - BLACK&DECKER KD561 Manual De Instrucciones

ENGLISH
USING YOUR DRILL
While your drill is in operation, do not touch the chuck.
HANDY HINTS
• Fit the correct size and type of drill or screwdriver bit.
• Set the correct drill speed.
• Always hold your drill using the handle and the
side handle.
• Always hold your drill at right-angles to your work.
• Set the forward/reverse switch to the correct direction.
• Never change the direction of rotation when your
drill is in operation.
• After use, remove the drill bit and gently tap the side
of the chuck with a soft-faced hammer to remove
the dust. This will extend the life of the chuck.

COOLING DOWN

If your drill becomes too hot in use, set the speed
control to its highest setting and allow your drill to
operate without load for 2 minutes.
24
OVERLOAD
To switch your Never use excessive force when using your drill. Too
drill on, depress much pressure can reduce the speed of your drill and
the on/off switch. reduce its efficiency. This can result in an overload
Your drill stops
which can cause damage to the motor of your drill.
when the on/off

EC DECLARATION OF CONFORMITY

switch is released.
We declare that units: KD561, KD562, KD564RE,
If continuous
KD564CRE, KD661, KD662, KD664RE, KD664CRE
operation is
conform to 89/392/EEC, 89/336/EEC, EN55014,
required, depress
73/23/EEC, EN55104, EN50144
the lock-on button
A weighted sound pressure 100dB (A)
while the on/off
A weighted sound power 113dB (A)
switch is depressed.
Hand/arm weighted vibration 8.7m/s
To stop your drill
when operation is
continuous, depress
the on/off switch
Brian Cooke - Director of Engineering
again and release.
Black & Decker Ltd, Spennymoor, County Durham
DL16 6JG United Kingdom
The Black & Decker policy is one of continuous
improvement to our product and as such we reserve
the right to change the product specification without
prior notice.
When drilling
wood and metal,
set the hammer
switch to the drill
mode .
When drilling
masonry, set the
hammer switch
to the hammer
mode .
When screwdriving,
set the hammer
switch to the drill
mode .
2