Beko WTE 11735 XCMST Manual Del Usuario página 23

4.4.4 Cleaning the water intake filters
There is a filter at the end of each water intake valve at the rear of the machine and also at the end of each
water intake hose where they are connected to the tap. These filters prevent foreign substances and dirt in
the water to enter the washing machine. Filters should be cleaned as they do get dirty.
4.4.5 Draining remaining water and cleaning the pump filter
The filter system in your machine prevents solid items such as buttons, coins and fabric fibers clogging the
pump impeller during discharge of washing water. Thus, the water will be discharged without any problem and
the service life of the pump will extend.
If the machine fails to drain water, the pump filter is clogged. Filter must be cleaned whenever it is clogged or
in every 3 months. Water must be drained off first to clean the pump filter.
In addition, prior to transporting the machine (e.g., when moving to another house) and in case of freezing of
the water, water may have to be drained completely.
A
CAUTION:
CAUTION:
against any likely freezing.
CAUTION:
In order to clean the dirty filter and discharge the water:
1 Unplug the machine to cut off the supply power.
A
CAUTION:
after the water inside the machine is cooled down.
2. Open the filter cover.
Washing Machine / User's Manual
1.
2.
3.
4.
Foreign substances left in the pump filter may damage your machine or may cause noise problem.
If the product is not being used, shut the tap shut, remove mains pipe and drain the water inside the machine
After each use, turn off the water tap to which the mains hose is connected.
Temperature of the water inside the machine may rise up to 90 ºC. To avoid the burning risk, clean the filter
Close the taps.
Remove the nuts of the water intake hoses to access
the filters on the water intake valves. Clean them with an
appropriate brush. If the filters are too dirty, remove them
from their places with a pliers and clean in this way.
Take out the filters on the flat ends of the water intake
hoses together with the gaskets and clean thoroughly
under running water.
Replace the seals and filters carefully and tighten their
nuts by hand.
23 / EN