Schumacher Electric Serie XP Manual Del Usuario página 5

6. Crank the engine for no more than
8 seconds. If the engine does not start,
wait 2 minutes before cranking again.
7. After the engine starts, turn the switch
to the OFF position and remove the
Instant Power from the battery.
8. Charge the Instant Power.
USING THE USB PORT
(Model XP750C)
The USB port provides up to 2A
at 5V DC.
1. Ensure the battery clamps are
securely clipped on the storage
holders.
2. Turn the Instant Power ON.
3. Plug your device into the USB port.
4. When finished using the USB port,
turn the switch to the OFF position.
5. Charge the Instant Power.
USING THE WORK LIGHT
The work light is controlled by a sliding
ON/OFF switch located on the front of
the Instant Power. Make sure the lamp
is turned OFF when the unit is being
recharged or stored.
Position the Instant Power on a flat, stable
surface near the intended work area.
Ensure the battery clamps are securely
clipped on the storage holders.
POWERING A 12V DC DEVICE
The Instant Power is a power source for
all 12V DC accessories that are equipped
with a 12V accessory plug. Use it for power
outages and on fishing or camping trips.
NOTE: Do not power a 12V device with
the Instant Power while charging the
internal battery.
1. Make sure the device to be powered
is OFF before inserting the 12V DC
accessory plug into the 12V DC
accessory outlet.
2. Open the protective cover of the DC
power outlet on the Instant Power.
3. Plug the 12V DC device into the DC
power outlet and turn on the 12V DC
device (if required).
4. When finished, turn off the DC device
(if required) and unplug from the DC
power outlet.
CAUTION: Do not use the Instant Power
to run appliances that draw more than
15A DC.
NOTE: Extended operation of a 12V DC
device may result in excessive battery
drain. Recharge the Instant Power
immediately after unplugging the 12V
DC device.
Estimated run-times
APPLIANCE
TYPE
Cell phone
Fluorescent
light
Radios, fans
Depth finder
Camcorder
Electrical tool
Electric cooler
Car vacuum,
air compressor
NOTE: Actual time may vary. Times are based
on the internal battery being fully charged.
USING THE AIR COMPRESSOR
(Model XP750C)
WARNING. Read the instructions of the
product being inflated before using the
compressor. Avoid overinflation; do not
exceed the manufacturer's recommended
pressures. Do not leave the air
compressor unattended during use.
NOTE: Wrap cleats are provided for
convenient storage of the air compressor
hose. Wrap the hose around these cleats
when the hose is not in use.
1. Remove the air compressor hose from
the storage cleats.
2. Connect the adaptor to the valve
stem and close the thumb latch. If
necessary, use one of the additional
adaptors.
3. Press the air compressor power
switch to turn ON and inflate to the
desired pressure or fullness (refer to
the gauge next to the switch).
4. When the desired pressure is
reached, press the air compressor
power switch to turn OFF, open the
thumb latch and remove the connector
from the valve stem.
5. Allow unit to cool.
6. Recharge the unit before storing.
NOTE: The air compressor is rated for
150 PSI.
Estimated time for inflating
Vehicle tires 13-16"
Bike tires
Sports balls
These times are approximate. Use the air
compressor gauge to ensure the proper
pressure has been reached. Do not overinflate.
• 5 •
EST
XP400
WATTAGE
4 watts 13 hrs
4 watts 15 hrs
9 watts 6.7 hrs
9 watts 6.7 hrs
15 watts 4 hrs
24 watts 2.5 hrs
48 watts 1.3 hrs
80 watts 0.8 hrs
6-24 minutes
1-3 minutes
30 seconds
XP750C
34 hrs
34 hrs
14 hrs
14 hrs
7 hrs
5 hrs
2 hours
1.8 hrs