Technical Information; Installation Considerations - Hansgrohe Unica'E 06890 0 Serie Instrucciones De Montaje

English

Technical Information

Max. flow rate -
04344xxx
06497xxx
all others

Installation Considerations

• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The screws and anchors included with this set
are suitable for use in a tile or other solid surface
wall. They are not suitable for use in an acrylic
or fiberglass shower enclosure. Please contact
the manufacturer of the enclosure regarding
recommended mounting locations, reinforcement
requirements, and mounting hardware.
• This unit does not include a wall supply. It must
be used with Hansgrohe model 27458xx3
or another approved supply that complies
with ASME A112.18.1/CSA B125.1 including
ASME A112.18.3.
This unit meets or exceeds the
following:
• ASME A112.18.1/CSA B125.1
• Listed by IAPMO for use in the
US and Canada
• Handshowers #04344xx0
(included with set #04519xx0)
and #06497xx0 (included
with set #27744xx1) are
WaterSense certified.
2
2.0 GPM (7.6 L/min)
1.5 GPM (5.7 L/min)
2.5 GPM (9.5 L/min)
• Handshower #04344xxx (Raindance E 100 AIR
Green) is intended for use with an automatically
compensating valve rated at 1.5 GPM
(5.7 l/min) or less @ 45 PSI (0.3 Mpa).
• Handshower #06497xxx (Croma E 75 EcoAir) is
intended for use with an automatically compensating
valve rated at 1.1 GPM (4.2 l/min) or less @ 45 PSI
(0.3 Mpa).
• To prevent scald injury, the maximum output
temperature of the shower valve must be no
more than 120° F (49° C).In Massachusetts,
the maximum output temperature of the shower
valve can be no higher than 112° F (44° C).
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product
in a safe place. The receipt is required should it
be necessary to request warranty parts.