Using Spray Nozzle; How To Apply Detergent - Ford FPWG30TA-J Manual De Uso

Using Spray Nozzle (See fig 19)
• To connect or disconnect spray tip, pull back on the quick-connect collar. Insert or remove spray tip then release collar.
• When spray tip is connected, pull on the spray tip to make sure it is secured.
• For general cleaning use the 40° spray tip. This option is for cement walkways.
• For stripping, spot cleaning, blasting, and hard to reach areas use the 15° spray tip. This option is for removing paint,
rust, mildew, marine growth off boats, or grease stains. This option can be used for reaching second story surfaces, or
for the removal of paint, rust, oil stains, tar, gum, and other stubborn substances. Use extreme caution when using this
nozzle.
• For applying pressure washer safe detergent, use the black soap nozzle.
Risk of Injection or Severe Injury – Keep Clear of Nozzle – Do Not Direct Discharge Stream
WARNING!
at Persons – This Product Is To Be Used Only By Trained Operator.
Applying Detergent
• Rinse surface with cool water before applying cleaner.
• Prepare detergent as required by job. For best results follow detergent directions as supplied from manufacturer.
• Remove cap from detergent container and fill.
• Spray detergent on surface. For best results use long, even, and overlapping strokes. Allow detergent to set for about
3 minutes before rinsing, but do not allow detergent to dry on surface or it may cause streaking or cause damage to the
surface. Use good judgment.
• To clean equipment after use, flush water through the spray nozzle for 1-2 minutes then shut off engine. Soak nozzle in
a bucket of clean water to remove detergent.
Only use detergents or soaps that are safe to be used with pressure washers. Chemicals
WARNING!
which are caustic, such as acids or bleach, can result in serious injury, property damage,
or death.
Rinsing with the Pressure Washer
Test a small area first to avoid surface damage.
•
• Rinse from top to bottom using long, overlapping strokes.
Moving the Pressure Washer
• Turn the pressure washer off.
• Tilt unit towards you until it is balanced on its wheels.
• Roll machine to desired location.
Do not overreach or stand on unstable support. Keep good footing and balance at all times.
WARNING!
Keep operating area clear of all persons.
WARNING!
OPERATION
18
SPRAY
WAND
NOZZLE
"CLICK"
FIG 19